SATO CL412e - Page 8

Graphics, Custom Recall ....................5-
Graphics, Custom Store ....................5-
Graphics, BMP Recall .....................5-
Graphics, BMP Store ......................5-
Graphics, PCX Recall ......................5-
Graphics, PCX Store ......................5-
Initialize ............................5-
Memory Area Select ......................5-
Status .............................5-
Custom Protocol Codes Download.................5-
Two-Dimensional Symbols.....................5-
Data Matrix, Data Format ...................5-
Data Matrix, Data Print ....................5-
Dat Matrix Sequential Numbering ...............5-
Maxicode............................5-
PDF417 ............................5-
Configuration Commands .....................5-
Custom Protocol Download ..................5-
Printer Setting .........................5-
Print Mode ...........................5-
Print Type ...........................5-
Pitch Offset...........................5-
Sensor Type ..........................5-
Serial I/F Parameters .....................5-
SECTION 6. INTERFACE SPECIFICATIONS
Introduction ..............................6-
Interface Types ............................6-
The Receive Buffer ..........................6-
IEEE1284 Parallel Interface ......................6-
Electrical Specifications ......................6-
Data Streams ...........................6-
Interface Pin Assignments .....................6-
RS232C Serial Interface ........................6-
General Specifications .......................6-
Electrical Specifications
Pin Assignments ..........................6-
Ready/Busy Flow Control .....................6-
X-On/X-Off Flow Control .....................6-
Universal Serial Bus (USB) Interface .................6-
Local Area Network (LAN) Interface .................6-
Bi-Directional Communications ....................6-
ENQ/ACK/NAK ..........................6-
Status Response ..........................6-
Accessory (EXT) Connector ......................6-
Pin Assignments ..........................6-
Standard Operation ........................6-
Page - vi PN 9001074 Preliminary SATO CL “e” Series Printers
Preface