<ESC>Q1
<ESC>Z
If you are using a 2 inch wide label, the entire image may not appear on your label.
By adding the following Base Reference Point command to the second line of the data
stream, the base reference point will be changed, causing the image to be shifted over
toward the inside of the printer where it can be printed on the narrower label.
<ESC>A
<ESC>A3H1374V0001
<ESC>H0050<ESC>V0100<ESC>L0303<ESC>XMSATO
<ESC>H0050<ESC>V0200<ESC>B103100*SATO*
<ESC>H0170<ESC>V0310<ESC>L0101<ESC>XUSATO
<ESC>Q1
<ESC>Z
The image is moved horizontally to the right 4.5 inches (1374 dots) so that it can be
printed on a 2 inch wide label.
SATO CL Series“e” Printers PN 9001074 Preliminary Page 5-7
Section 5. Programming Reference
Label
6.5"
2"
Label
6.5"
SATO
H=50
V=100
V=200
V=310
H=70
SATO
To Next Page
Loading...
