SawStop PCS175 - Standing Up Your Saw

16 SawStop 10” Professional Cabinet Saw
Standing Up Your Saw
!
WARNING
Do
no
t o
perate
with
door open.
The blade can
retract and cause
a severe injury if you
t
o
uch it inside
the cabinet. Also, movin
g
p
ar
ts can
cut, pinch or
cr
ush
.
!
WARNING
D
o n
ot
o
perate wit
h
door o
pen.
The blade can retract
and cause
a severe
injury if you touch it in
side
the ca
b
inet. Also,
mov
in
g parts can
cut, pin
c
h or crus
h
.
!
WARNING
Moving gea
rs and parts
can pinch,
cut or crush
.
Do not ope
rate with
door ope
n.
!
WARNING
Do
not operate with door open.
The blade can retract and cause
a severe
i
njury if
y
ou
to
uc
h it inside
the cabinet. Also, moving parts can
c
ut, pinc
h
or
cru
sh
.
1. Your saw is shipped horizontal to protect it from tipping during transit. To stand up your saw, fi rst remove all
packing materials and accessories from the shipping pallet (see Fig. 1). There is a poster that ships with the
saw that shows where all of the accessories are located in the packaging.
2. Take the top piece of Styrofoam and place one of its short sides next to the pallet by the back of the saw, as
shown in Fig 2a. Place the Styrofoam so that the top edge of the table and the bottom edge of the saw both
overhang the edges of the Styrofoam (see Fig. 2b).
Fig. 2a
Fig. 1
Fig. 2b
top piece of
Styrofoam
the bottom edge
of the saw should
overhang the edge
of the Styrofoam
the edge of the
table should
overhang the edge
of the Styrofoam