EasyManua.ls Logo

Scania DI13 series - Air Cleaner Service; Air Cleaner Maintenance Procedures

Scania DI13 series
74 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPM 250 en-GB 48
©
Scania CV AB 2016, Sweden
Air cleaner
Air cleaner
Reading the air cleaner vacu-
um indicator
If the indicator's red plunger is fully visible, re-
new the air cleaner filter element following the
instructions below.
Renewing the air cleaner filter
element
This procedure applies if the engine is fitted with
a Scania air cleaner.
WARNING!
Never start the engine without the air filter being
in place. If you do, this could cause injury and se-
vere engine damage.
Note:
Renew the filter element earlier than the mainte-
nance interval if the indicator shows red.
There is always a risk that the filter element will
be damaged when it is cleaned.
The filter element must not be cleaned in water
or be blown clean with compressed air.
1. Remove the cover from the air cleaner.
2. Renew the filter element.
3. Insert a torch into the element and check
from the outside that there are no holes or
cracks in the filter paper.
4. Assemble the air cleaner.
5. Reset the vacuum indicator by pressing the
button.
A B
336 100
A Vacuum indicator.
B Filter element.
326 671
Resetting the vacuum indicator.

Table of Contents

Related product manuals