Scania PDE User Manual

DI13
Marine engine
en-GB 2 291 901
Issue 1.0
Operator's manual
PDE
Important information
Serious risk of injury
When working on the engine, for example when adjusting drive belts and the clutch, or when changing the
oil, it is important not to start the engine. The engine could be damaged, but more importantly there is a
serious risk of injury.
For this reason, always secure the starting device or disconnect a battery cable before working on the engine.
This is especially important if the engine has a remote starter or automatic starting.
WARNING!
This warning symbol and text can be found next to those inspection points where it is particularly important
to bear in mind the risk of injury.
Start-up Report – Warranty
When the start-up report has been filled in and sent to Scania, you have a 1-year warranty from the date of
entry into service. Fill in the particulars below as well. This can make things easier if you need to contact a
workshop for example.
Engine type and variant are indicated on the engine data plate.
Engine serial number
Date of entry into service
User's name and address
Signature
Engine type
Variant

Scania PDE Specifications

General

Type	Diesel
Actuation	Electronic
Engine Type	Inline
Cylinders	6
Torque	2550-3500 Nm
Cooling System	Liquid Cooled

Summary

Important Information

Serious Risk of Injury

Warning about potential injury when working on the engine.

Component Identification

Engine Component Layout

Starting and Running

Engine Starting Procedure

Engine Shutdown and Post-Run Checks

Inspection

Inspection Intervals Schedule

Lubrication System

Oil Grade Selection and Analysis

Guidance on selecting oil grade, analysis, and level checks.

Oil Change and Filter Replacement

Step-by-step instructions for draining oil and replacing the oil filter.

Centrifugal Oil Cleaner Maintenance

Cooling System

Coolant Properties and Cold Resistance

Coolant Level and Antifreeze Checks

Procedures for checking coolant level and antifreeze content.

Coolant Changing and Cleaning

Steps for draining, filling, and cleaning the cooling system components.

Air Cleaner

Vacuum Indicator and Filter Replacement

How to read the vacuum indicator and replace the air filter element.

Fuel System

Fuel Properties and Filter Replacement

Fuel Filter Renewals and Bleeding

Bleeding the Fuel System

Step-by-step guide for bleeding the fuel system after filter changes.

Miscellaneous

Leak Checks and Valve Adjustment

Unit Injector Adjustment

How to check and adjust unit injectors using setting tools and specifications.

Engine Storage Preparation

Handling and Preservative Fluids

Storage Preparation Procedures

Comprehensive steps for preparing the engine for long-term storage.

Returning Stored Engine to Operation

Technical Data

General Engine Specifications

Key technical data for the Scania engine, including dimensions and weights.

System Specifications

Technical data for injection, cooling, intake, and electrical systems.