Scanlab RTC 4 - Page 127

RTC
®
4 PC Interface Board
Rev. 1.3 e
10 Commands And Functions
127
innovators for industry
Ctrl Command set_co2_standby
Support status This RTC
®
2 command is not supported by the RTC
®
4.
Replaced by set_standby (see page 116)
List Command set_co2_standby_list
Support status This RTC
®
2 command is not supported by the RTC
®
4.
Replaced by set_standby (see page 116)
List Command set_delays
Support status This RTC
®
2 command is not supported by the RTC
®
4.
Replaced by set_laser_delays (page 107) and set_scanner_delays (page 113)
Ctrl Command set_gain
Support status This RTC
®
2 command is not supported by the RTC
®
4.
Replaced by set_matrix (page 110) and set_offset (page 111) or load_correction_file (page 95)
Ctrl Command set_mode
Support status This RTC
®
2 command is not supported by the RTC
®
4.
Replaced by There is no equivalent command for the RTC
®
4, because its image field correction
algorithm is always enabled. Instead, a 1-to-1 correction file can be loaded.
Ctrl Command set_speed
Support status This RTC
®
2 command is not supported by the RTC
®
4.
Replaced by set_jump_speed (page 107) and set_mark_speed (page 109)
Ctrl Command set_yag_parameter
Support status This RTC
®
2 command is not supported by the RTC
®
4.
Replaced by There is no equivalent command for the RTC
®
4.
Ctrl Command write_da
Support status This RTC
®
2 command is not supported by the RTC
®
4.
Replaced by write_da_1 (page 122)
List Command write_da_list
Support status This RTC
®
2 command is not supported by the RTC
®
4.
Replaced by write_da_1_list (page 122)