Schaeer Technologies
55
WARNING!
■ Carrying out the right maintenance and
following the instructions is important.
■ Contact your supplier if in doubt about the
correct functioning of the device.
■ Repairs must be carried out by the
manufacturer or a specialist approved by
the manufacturer.
3 54
Models with vertical ledge:
1. Remove dirt, burrs, etc., from the ledge and poles and
grease lightly.
2. Place the ledge in front of the poles.
3. Loosen the bolts on the ledge by about half a turn.
4. Switch on the heater by pressing start. The ledge now
sets itself. If necessary, a plastic (dead blow) hammer
may be used.
5. When noise reduces, then tighten all bolts and switch o
the heater.
To Next Page
Loading...