48 Schaeer Technologies
11. Other functionalities
11.1 Demagnetisation The workpiece is demagnetized each time the heating process
stops or is stopped manually. This is briefly displayed on
the screen.
11.2 Hold functionality In the temperature and the temperature & speed modes the
screen displays a slider with which the temperature hold
functionality “Temp. Hold” can be switched on or o.
This functionality enables a workpiece to be held at a set
temperature once that temperature has been reached.
Maintaining the temperature of a workpiece follows a certain
switching hysteresis (T hold hysteresis), which can be set
in the system settings as described in section 6.4. The
temperature set here is the temperature to which a workpiece
may drop before the heater switches on again automatically.
To Next Page
Loading...