Schaller RH2 - Deleting individual measurement series

Page 31
6. Press to leave the Edit Logs menu.
7. Press
to leave the main menu.
6.7 Deleting individual measurement series
To do so: You must have saved a measured value (e.g. 1
log) or a series of measurements (e.g. 3 logs). The display
will now appear as shown in figure 38.
1. Press
.
2. Select the required reading. To do so, press
or
.
» The display will now appear as shown in figure 39.
3. Press
to switch to another input level.
» The display will now appear as shown in figure 40.
4. Press
.
» The display will then show the message clear?
(figure 41).
5. Confirm by pressing
.
» The value has been deleted.
38
39
40
41