ww w.scheppach.com
GB
|
27
-
served.
arise due to non-observance of these instructions
2. Layout (Fig. 1-19)
1.
2. Overload switch
3. Switching pins
4. Chip extractor
5. Parallel stop
6. Star grip nut M8
7. Planing knife cover
8. Star grip nut M6
9. Clamping lever
10. Crank handle
11. Setting screw for chip depth
12. Feed table
13. Planing knife cover cpl.
14. Allen wrench
15. Ripped belt
16. Push stick
17. Allen screw
18. Allen screw
19. Spindle
20. Threaded spindle
21. Thicknessing table
22. Clamping lever
23. Clamping screw
24. Knife
25. Anti-kick claws
26. Planing table
27. Knife block
28. Push stick holder
29. Power cord
30. Cord holder
31. Setting screw
32. Fixing screw
33. Eccentric
A. Scale (Chip depth)
B. Scale (Parallel stop)
C. Scale (Thickness planer)
3. Scope of delivery (Fig. 1a/b)
• Open the packaging and remove the device care-
• Remove the packaging material as well as the
packaging and transport bracing (if available).
•
• -
port damage.
1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
Note:
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
•
technicians,
• Installation and replacement of non-original spare
parts,
•
•
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the
user to become familiar with the machine and take
advantage of its application possibilities in accord-
ance with the recommendations.
The operating instructions contain important infor-
-
-
-
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
were instructed concerning the operation of the ma-
chine and who are informed about the associated
dangers. The minimum age requirement must be
complied with.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
