ww w.scheppach.com
32
|
GB
Removing sawdust and chippings from the machine
the mains plug and remove the jammed workpiece.
Set the smallest cutting size after use to prevent the
m CAUTION!
-
top using suitable screws / screw clamps since oth-
erwise there is a risk that it will tip over.
•
are identical to the mains data.
• m WARNING! Before cleaning~, adjustment~,
maintenance~ or repair work, disconnect the pow-
• -
• The knives (24) must not project more than a maxi-
mum of 1.1 mm out of the knife block.
• Make sure that the anti-kick claws (25) work cor-
•
• Never cut concavities, tenons or shapes.
•
• It must be possible for the planing knife to run free-
8. Assembly
8.1 Parallel stop (Fig. 2)
• Now unscrew the Allen screws (17/18) coun-
• Now attach the parallel stop (5) to the machine
housing and fasten it using the Allen screws
(17/18).
8.2 Crank handle for thickness planer chip depth
(Fig. 3)
•
spindle (19)
8.3 Chip extractor - surface planing (Fig. 4-6)
• Set the planing knife cover cpl. (13) in the upperst
position.
• Use the crank handle (10) to place the Thickness-
ing table (21) in the lowest position.
• Take the chip extractor (4) and hold the switching
pins (3) beside. Place the chip extractor (4) at a
pins (3) outwards.
• Now lock the chip extractor (4) with the switching
pins in the table. Attention! The machine won´t
in.
• Screw in the screw (32) from the other side of the
machine to secure the chip extractor (4).
•
down again.
8.4 Chip extractor - thickness planing (Fig. 11)
• The parallel stop (5) needs to be removed for thick-
ness planing. Follow point 8.1 in reverse order.
• Now slide the planing knife cover (7) beside so that
• Hold the switching pins (3) outside and set the chip
extractor (4) on top of the machine.
• Now lock the chip extractor (4) with the switching
pins in the table. Attention! The machine won´t start
•
the chip extractor (4).
9. Operation
m IMPORTANT!: The surfacing and thicknessing
-
pose. The contact surface of the workpiece must be
place (e.g. using the thread in the machine base).
• The ON/OFF switch (1) is on the left-hand side of
machine.
•
to protect the motor. In the event of an overload,
time, the overload switch (2) can be reset again.
• To work on long workpieces, use roller tables or
a similar supporting arrangement. Such optional
plane. Their height must be adjusted such that the
workpiece is horizontal when it is fed into and out
of the machine.
9.1 Surfacing
m IMPORTANT!: Pull out the power plug before
work.
9.1.1 Adjustment (Fig. 7/8)
• Turn the adjustment knob for cutting depth (11) to
set the height of the feed table (12). The set cutting
To Next Page
Loading...
