ww w.scheppach.com
34
|
GB
Insert the plug of the electrical cable in a socket of
with current regulations.
Do not pull the service cable to pull the plug out of
socket.
The electric motor is connected in a ready-to-op-
erate state. The connection corresponds to the
relevant VDE and DIN regulations.
The mains connection at the customer’s work
place and the extension cable used must corre-
spond to these regulations.
• The product meets the requirements of EN 61000-
3-11 and is subject to special connection condi-
• Given unfavorable conditions in the power sup-
• -
tion points that
the mains of at least 100 A per phase.
• -
-
to operate the product meets one of the two re-
quirements, a) or b), named above.
Important information
In the event of an overloading the motor will switch
motor can be switched back on again.
Faulty electrical connecting leads
Insulation damage often occurs at electrical connect-
ing leads.
Causes include:
• Pressure marks caused when connecting leads
are run through windows or the cracks of doors.
• -
ning of the connecting leads.
• Cutsresulting from the crossing of the connecting
lead.
•
the connecting lead from the wall socket.
• Cracks due to the ageing of the insulation.
-
sulation damage.
-
age. Ensure that the connecting lead is not attached
•
The threaded spindle for height-adjustment of the
-
bricant agent.
The table surfaces as well as the infeed and output
•
• In order to avoid overheating of the motor, regular-
• After a longer period of use, it is recommended to
-
er service.
Tool care:
• Cutter block, clamping devices, knife supports
and -
To this purpose, clamping devices, knife supports
and knives can be put in a common resin remover
for 24 hours.
•
with cleaning liquids not being aggressive to this
Attention:
the performance can drop for a short period of time.
Ask a specialist.
11. Storage (Fig. 15)
Wrap the power cord (29) around the cable holder
(30) provided for this purpose. For the sliding cane
the sliding cane holders (28) are provided.
Store the equipment and accessories out of chil-
-
ing temperature. The ideal storage temperature is
between 5 and 30 °C.
Store the electric tool in its original packaging.
Cover the electrical tool in order to protect it from
dust and moisture.
Store the operating manual with the electrical tool.
12. Electrical connection
m WARNING! Electric shock! There is a risk of
an injury caused by electric shock!
-
self from electric shocks.
m
30mA).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
