ww w.scheppach.com
GB
|
29
17 Avoid unintentional starting
- -
ging in.
18 Use outdoor extension leads
- -
tension cords intended for outdoor use and
so marked.
19
-
are tired.
20 Check damaged parts
- Before further use of tool, it should be care-
- Check for alignment of moving parts, binding
of moving parts, breakage of parts, mounting
operation.
- A guard or other part that is damaged should
-
ized service centre unless otherwise indicat-
ed in this instruction manual.
- -
thorized service centre.
- Do not use the tool if the switch does not turn
21 WARNING!
- -
er than one recommended in this instruction
22
- This electric tool complies with the relevant
-
ble danger to the user.
-
SPECIAL SAFETY INSTRUCTIONS
• Do not use blunt knives. Risk of kick-back.
•
•
• -
use lateral pressure equipment and springloaded
• The machine is not suitable for cutting rebates.
7 Use the right tool
- Do not force small tools to do the job of a
- Do not use tools for purposes not intended;
or example do not use circular saws to cut
tree limbs or logs.
8
-
can be caught in moving parts.
- Non-skid footwear is recommended when
working outdoors.
- Wear protective hair covering to contain long
hair.
9 Use protective equipment
-
- Use face or dust mask if working operations
create dust.
10 Connect dust extraction equipment
- lf the tool is provided for the connection of
dust extraction and collecting equipment, en-
11 Do not abuse the cord
-
sharp edges.
12 Secure work
- Where possible use clamps or a vice to hold
13 Do not overreach
- Keep proper footing and balance at all times.
14 Maintain tools with care
- Keep cutting tools sharp and clean for better
and safer performance.
- Follow instruction for lubricating and chang-
ing accessories.
-
- -
place if damaged.
-
grease.
15 Disconnect tools
- When not in use, before servicing and when
changing accessories such as blades, bits
and cutters, disconnect tools from the power
-
it from the mains plug. Remove the workpiece
and make sure that the planer shaft runs free-
again with reduced feed force.
16
-
and adjusting wrenches are removed from the
tool before turning it on.
To Next Page
Loading...
