Watson-Ethernet-Manual.doc
Version 3.3-01
Watson Ethernet
Operating Manual
The plug-in which is configured as Master Agent also contains Sub-
agents. It is required to configure a MASTERIP address on this plug-
in. Cf. 8.1.1
MGMTIP Management-Port IP-Address/Netmask [ State ]
Sets the IP address and netmask of a management port.
Parameters:
One of the management ports (MGMT1, MGMT2 or
MGMT3)
IP address and network mask for this port. Use the /nn
notation for the network mask, e.g.
10.100.249.67/16.
The last part of the address can be replaced by the
keyword #S to represent the subrack slot number where
the card is inserted in.
Factory default:
192.168.0.#S/24 for MGMT1
192.168.1.#S/24 for MGMT2
Use address 0.0.0.0 to delete an address.
Status of the port (UP or DOWN)
The MGMTIP command is only available through the RS-232 Monitor interface,
not through Telnet.
RIP ON | OFF
Enables/disables the Routing Information Protocol. The Watson Ethernet plug-in
supports RIPv2 (RFC 1388). If RIP is enabled then there is no need to manually
set up routes using the ROUTE command. The current setting of RIP is dis-
played with the CONFIG MGMT command.
There are no configurable parameters for RIP
RIP is either active on all management ports (MGMT1, MGMT2 and
MGMT3) or completely disabled.
ROUTE [ ADD IP-Address/Netmask Gateway | DEL IP-Address/Netmask ]
Adds or deletes a static route to the management routing table.
Parameters:
ADD IP-Address/
Netmask Gateway
Adds a route to the destination IP-Address/Netmask
through the gateway Gateway.
Deletes a route to destination IP-Address/Netmask
ROUTE without parameters displays the routing table:
To Next Page
Loading...
