Schmid Watson - Page 88

Watson Ethernet
Operating Manual
Watson-Ethernet-Manual.doc
Version 3.3-01
7-26
Revision: 2010-01-20
LTU_01_CM> ROUTE
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Management Route Configuration
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Destination Mask Gateway
10.101.0.0 255.255.0.0 10.100.249.1
SNMPCOMMUNITY [ READ | WRITE Community-Name ]
Configures the SNMP read and write community strings. If the Community-
Name is to include lowercase letters then it must be enclosed in quotes " ".
SNMPCOMMUNITY without parameters will display the currently configured com-
munity strings.
Notes:
 This command is only available on the Master agent (MASTERAGENT ON)
 SNMP community strings are limited to 32 characters in length
SNMPTRAP ADD|DEL Destination Port Version Community-Name
Configures SNMP trap destinations.
Parameters:
ADD
Add destination
DEL
Delete destination. To identify the destination to be de-
leted it is required to enter all trap parameters (Desti-
nation, Port, Version and Community-Name)
Destination
IP - Address of the trap destination
Port
protocol port (default 162)
Version
SNMP version (V1 or V2, default is V1)
Community-Name
Trap community name (default is the currently confi-
gured SNMP read community).
It is possible to configure several trap destinations. Traps will be sent to all confi-
gured destinations. Use CONFIG MGMT to display the current list of trap destina-
tions.
Notes:
 This command is only available on the Master agent (MASTERAGENT ON)
 Trap community strings are limited to 32 characters in length