en
5 /
STD−Wa 08/0075 71099235Screw Connections, Filling of Gaps, Sealing Material and Product Recommendations
2 Filling of Bore Holes and Gaps
NOTE
If it is required to fill gaps or bore holes with water−proof
rapid cement, then this is marked in the construction
drawing.
D Parts have to be painted.
D Surfaces must be clean, dry and free from grease.
NOTE
The rapid cement can be ordered from SCHOTTEL by
stating the order no., see chapter ”Product
recommendation”.
!
CAUTION
Wear protective clothing during the operation!
RISK OF CHEMICAL BURNS
The cement dust must not enter in contact with the eyes
or respiratory tract.
1. Insert plugs into the heads of hexagon socket
screws (3/1).
2. Prepare the required quantity of rapid cement to
instructions of the manufacturer.
3. Fill bore holes / gaps with rapid cement (3/2).
4. Leave the rapid cement cure to instructions of the
manufacturer.
5. Level the outline by grinding and renew the paint
coat according to the corresponding specification.
1
2
Figure 3
To Next Page
Loading...
