Assembly
40
14.00 | JGP | Assembly and Operating Manual | en | 389157
Ø Move product to the "gripper open" position.
Ø Loosen screw (4) and remove control cam (6) for the inductive
monitoring from the base jaw.
Ø Remove screw (5) from the base jaw.
Ø Apply adhesive to the top and sides of the control cam (6) from
the mounting kit.
✓ Make sure that there is no adhesive on the bottom of the
control cam (6), which comes into contact with the sensor.
✓ SCHUNK recommends the adhesive Loctite 290 or 638.
Ø Slide control cam (6) into the base jaw to the stop.
✓ Ensure that the higher front side of the control cam(6) is
pointing outwards.
Ø IMPORTANT!The control cam (6) must no longer move after it
is screwed on.
Screw the control cam (6) to the base jaw using the screw (5).
✓ Secure the screw (5) with medium-strength locking liquid.
Ø Slide the sensor (1) to the stop into the bracket (2).
Ø Tighten the screw (3) on the bracket (2).
Tightening torque: 0.2 Nm
Ø Adjust sensor (1), see assembly and operating manual of the
sensor.
To Next Page
Loading...
Need help?
General
