SCHUNK JGP - Maintenance; Notes; Maintenance intervals

Maintenance
14.00 | JGP | Assembly and Operating Manual | en | 389157
45
7 Maintenance
7.1 Notes
Original spare parts
Use only original spare parts of SCHUNK when replacing spare and
wear parts.
Exchange of housing and base jaws
The base jaws and the guidance in the housing are matched. To
exchange these parts, send the product with a repair order to
SCHUNK or order the housing with the base jaws as a set.
Type 40-100:
Maintenance of module with gripping force maintenance "A.D.
gripping" (A.D.)
The pistons have to be aligned using an assembly device.
Therefore we recommend to have the module serviced and the
seals replaced by SCHUNK.
If this is not possible, you can carry out the maintenance and
replace the seals yourself.
7.2 Maintenance intervals
CAUTION
Material damage due to hardening lubricants!
Lubricants harden more quickly at temperatures above 60°C,
leading to possible product damage.
• Reduce the lubricant intervals accordingly.
Interval (million cycles)
for JGP
Maintenance work
40 - 160 200 - 300
2 1 Clean all parts thoroughly, check for
damage and wear, if necessary replace
seals and wearing parts,
Disassembly and assembly [
}
46].
The seals are in the enclosed sealing kit.,
Seal kit [
}
8].
2 1 Treat all grease areas with lubricant,
Lubricants/Lubrication points [
}
46].
Oil or grease external steel parts.