SCHUNK KSP3 - Table of Contents

02.00 | KSP3, KSP3-LH, KSP3-F | Assembly and Operating Manual | en |
1463318
3
Table of Contents
Table of Contents
1 General .................................................................................................................... 5
1.1 About this manual ................................................................................................... 5
1.1.1 Presentation of Warning Labels ................................................................. 5
1.1.2 Applicable documents ................................................................................ 5
1.1.3 Sizes ............................................................................................................ 6
1.2 Warranty ................................................................................................................. 6
1.3 Scope of Delivery .................................................................................................... 6
2
Basic
safety notes ...................................................................................................
7
2.1
Intended use.........................................................................................................
7
2.2
Not intended use ..................................................................................................
7
2.3
Constructional changes ........................................................................................
7
2.4
Spare parts ...........................................................................................................
7
2.5
Use of special chuck jaws .....................................................................................
7
2.6
Environmental and operating conditions .............................................................
8
2.7
Personnel qualification.........................................................................................
8
2.8
Personal protective equipment ............................................................................
9
2.9
Notes on safe operation .......................................................................................
9
2.10 Transport ............................................................................................................... 10
2.11 Malfunctions ......................................................................................................... 10
2.12 Disposal ................................................................................................................. 10
2.13 Fundamental dangers ........................................................................................... 10
2.13.1 Protection during handling and assembly ................................................ 11
2.13.2 Protection during commissioning and operation ..................................... 11
2.13.3 Protection against dangerous movements .............................................. 11
2.13.4 Notes on particular risks ........................................................................... 12
3 Technical data ........................................................................................................ 14
4 Tightening torques for screws ................................................................................. 17
5 Assembly and connection ....................................................................................... 18
5.1 Assembly of the Clamping Block on the machine table ....................................... 18
5.2 Mounting the clamping block on the base plate .................................................. 19
5.3 Connecting the clamping force block ................................................................... 21
5.3.1 Supply lines ............................................................................................... 22
5.3.2 Dynamic pressure monitoring of the jaw end positions (variant "PM")
................................................................................................................ 22
5.3.3 Air coupling in top jaw (variant "PM").................................................... 23
5.3.4 Pneumatic circuit diagram ........................................................................ 25
6 Troubleshooting ..................................................................................................... 26