SCHUNK KSP3 User Manual

Maintenance and care
28
02.00 | KSP3, KSP3-LH, KSP3-F | Assembly and Operating Manual | en |
1463318
7 Maintenance and care
7.1 Notes
Original spare parts
Only use original spare parts from SCHUNK when replacing
wearing parts/spare parts.
Replacement of the housing and base jaws
The base jaws and the guides in the housing are matched to each
other. To replace these parts, send the entire product to SCHUNK
with a repair order.
Maintenance variant with clamping force maintenance (AS)
The cylinder piston must be disassembled or assembled using a
disassembly and assembly device. We therefore recommend you
have maintenance work and change of seals performed at
SCHUNK.
7.2 Maintenance and lubrication intervals
The following maintenance work should be carried out after the
specified cycle numbers or at the latest after the monthly data.
Maintenance work
Interval [cycles/month]
Lubricate
10,000 / 1
Basic cleaning
- / 6
Leak test
5,000 / 1
7.3 Greasing areas / lubricants
Greasing areas
Lubricants
Sliding surfaces body - base jaw
LINOMAX 200
Sliding surfaces base jaw -
chuck piston
LINOMAX 200
Lubrication nipple
LINOMAX 200
Central lubrication
LINOMAX 200
All seals
RENOLIT HLT 2
Sliding surfaces cylinder piston
- housing
RENOLIT HLT 2
(Product information for LINOMAX 200 can be requested from
SCHUNK).

SCHUNK KSP3 Specifications

General

Brand	SCHUNK
Model	KSP3
Category	Industrial Equipment
Language	English