SDKELI BLPS-D3L - Dimensions

- 9 -
The front protection area is formed in the range of L1 receiving hole, and the middle
protection area is formed in the range of L2 and L3 receiving holes.
Fig.1.4 Panel of sensor
Sensor
LED
indicators
Color
Description
Emitter
No
Receiver
Power
Orange
Turns on when the power is on.
On
Green
ON state indicator light, when OSSD outputs ON state, the light is on. At
this time, allow the controlled device to run.
Off
Red
OFF state indicator light, when OSSD output OFF state, the light is on.
At this time, the controlled equipment is not allowed to operate.
Fault
Red
Fault status indicator, when the receiver body fails, the indicator light is
always on. At this time, OSSD outputs the OFF state, and the controlled
equipment is not allowed to run.
Shunt
indication
Red
Shunt indicator light, when the detection beam is in shading state, the
light is on.
1.4.2 Dimensions
Fig.1.5 Dimensions of sensor