- 3 -
Ⅰ．Legislation and standards
BLPS-D3L Laser Safety Protective Device（Hereinafter referred to as“BLPS”）complies with
the following standards:
EU legislations
Machinery Directive 2006/42/EC
EMC Directive 2014/30/EU
European Standards
EN 61496-1 (Type 4)
EN 61496-2 (Type 4 )
EN 60825-1 (class 1 laser product)
EN 13849-1 (PL e)
International Standards
IEC 61496-1 (Type 4 )
IEC 61496-2 (Type 4 )
ISO 13849-1 (PL e)
National Standards
GB/T 19436.1
GB/T 19436.2
GB 28243
GB 7247.1
GB 4208(IP65)
Ⅱ
．
User instructions
Read this manual thoroughly and confirm the product from the appearance before installing,
operating and maintaining BLPS. Please contact us if you have any questions or comments.
(1) Limitations of Liability
The quality guarantee period of BLPS is 12 months.
KELI makes no warranty or representation, express or implied, regarding non-infringement,
merchantability, or fitness for particular purpose of the products. Any buyer or user
acknowledges that the buyer or user alone has determined that the products will suitably meet
the requirements of their intended use. KELI disclaims all other warranty, express or implied.
(2) Limitations of Liability
KELI shall not be responsible for special, indirect, or consequential damages, loss of profits
or commercial loss in any way connected with the products, whether such claim is based on
contract, warranty, negligence, or strict liability.
In no event shall responsibility of KELI for any act exceed the individual price of the product
on which liability is asserted.
In no event shall KELI be responsible for warranty, repair, or other claims regarding the
products unless KELI’s analysis confirms that the products were properly handled, stored,
installed, and maintained and not subject to contamination, abuse, misuse, or inappropriate
modification or repair.
(3) Performance
Performance data given in this document is provided as a guide for the user in determining
suitability and does not constitute a warranty. It may represent the result of KELI’s test
To Next Page
Loading...