- 30 -
Section3 Installation and wiring
Before installation, please read carefully the notes and warning information of this manual in
order to avoid the personal injury caused by wrong installation.
BLPS can only be applied to the bender that is produced in compliance with the
machinery safety regulations and accident prevention rules and regulations.
Installing BLPS laser safety protection on the bending must be carried out by the
trained professionals.
Installation personnel must understand the operation and associated risk factors of the
bender, and be familiar with the operation of BLPS.
The adjustment of BLPS should be done by the professionals. The professionals must
have passed the comprehensive training of the bender and BLPS.
During installation, ensure that the the bender is stopped. Otherwise, it may cause
personal injury.
BLPS cannot be applied to the safety protection of non- electrical equipments. Other
wise, before the operator touches the dangerous parts, the bender cannot stop and
cause serious injury.
Do not use BLPS in the flammable and explosive environments, otherwise it may
cause an explosion.
BLPS do not protect against splashes, when there are splashes that are dangerous to
human bodies in the hazardous areas, the shield or protective nets should be added to
protect operators.
3.1 Installation suggestion
3.1.1 Interference prevention measures
Reflective surface interference
Metal processing glossy surface may cause reflection of the laser beam resulting in detection
error of sensors. To avoid such error, gearshift point of the bender should be set referencing to
3.1.2.
Fig.3.1 Reflective surface interference
External light interference
When there is the following light in the wroking environment, it may cause detection error of
sensors.
1）Stroboscopic light
2）Other infrared laser light
In order to avoid external light interference, isolation device should be installed between the
To Next Page
Loading...
