- 4 -
conditions, and the users must correlate it to actual application requirements.
(4) Change in Specifications
Product specifications and accessories may be changed at any time based on improvements
and other reasons.
When the product's rating, performance, or structure changes, the product's specifications will
change accordingly. For the change of product specifications, our company will not notify, if
in doubt, please contact us.
(5) Errors and Omissions
The contents of the manual have been made as accurate and complete as possible, but there is
no guarantee that there are no errors or omissions in this manual.The Company shall not be
responsible for any errors or omissions that may have occurred in this specification.
(6) Copyright and Copy Permission
This document shall not be copied for sales or promotions without permission.
This document is protected by copyright and is intended solely for use in conjunction with
BLPS. Please notify us before copying or reproducing this document in any manner, for any
other purpose. If copying or transmitting this document to another, please copy or transmit it
in its entirety.
Ⅲ. Precautions on safety
The following special information may appear at any place in the manual or on BLPS, as a
warning of potential risk or promotion of special attention to information about clarifying or
simplifying certain procedures.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
WARNNING indicates an actual or potential risk or
health hazard. They are designed to help you to prevent
accidents. Read carefully and follow the warnings!
CAUTION indicates the key information which, if not
avoided, can result in expected legal dispute, or
equipment damage.
Read carefully and follow the cautions!
Ⅳ.Precautions for safe use
Make sure to observe the following precautions that are necessary for ensuring safe use of the
product.
(1) Thoroughly read this manual and understand the installation procedures, operation check
procedures, and maintenance procedures before using the product.
(2) BLPS should only be installed, checked, and maintained by a qualified person. A
qualified person is defined as a person or persons who, by possession of a recognized
degree or certificate of professional training, or who, by extensive knowledge, training
and experience, has successfully demonstrated the ability to solve problems relating to
the subject matter and work.
(3) The OSSDs of the sensor should not be short-circuited with the anode or cathode of the
To Next Page
Loading...