SDKELI BLPS-D3L

To Next Page

To Previous Page

3.5.1 Wiring considerations ........................................................................................................- 39 -

3.5.2 Power supply ..................................................................................................................... - 40 -

3.5.3 Wiring procedures ..............................................................................................................- 40 -

Section4 Check and debugging .................................................................................................................. - 43 -

4.1 Installation condition check ..........................................................................................................- 43 -

4.2 Wiring check before switching on power supply .........................................................................- 43 -

4.3 Operation check while the bender is stopped ...............................................................................- 43 -

4.4 Operation check while the bender operates ..................................................................................- 44 -

Section5 Maintenance .................................................................................................................................- 45 -

5.1 Inspection at startup and when changing operators ..................................................................... - 45 -

5.2 Inspection for the guarded machine ............................................................................................. - 45 -

5.3 Items to inspect every 6 months or when machine settings are changed .....................................- 45 -

Section6 Troubleshooting ........................................................................................................................... - 47 -

6.1 Fault analysis ................................................................................................................................ - 47 -

6.2 Braking system fault of the bender ...............................................................................................- 48 -

Main Page

SDKELI BLPS-D3L - Page 3

Table of Contents

Related product manuals