13 Taking a temperature, humidity and
dewpoint measurement using the
HumT1 sensor
The HumT1 sensor must be connected to the black collar LEMO connector.
Select the HumT1 sensor using the F1 button, if necessary.
13.1 Settings
Press F3 to select:
The physical unit. The choice is Celsius, Kelvin, Rankin, Fahrenheit.
Use the F1 button to save the settings as a preferred configuration
Use the F2 button to load your preferred configuration
Use the F3 button to use a one-shot configuration, without saving it.
13.2 Getting and saving data
The data recording function is not available on the SDT270 SB version. To check your SDT270 version, please refer to the
chapter "System Info".
Press the M button to freeze a measurement.
Press the Disc button to save the data or F1 to come back to the measurement screen without saving.
When saving, choose the desired memory location using the Up and Down arrow buttons and confirm by pressing the
Enter button.
To Next Page
Loading...