MAN.270.EN--05--SDT270-user-manual-Eng.docx
15.1.9 End of survey
After recording the last measurement of the Survey, the SDT270 indicates you have completed the data collection by
displaying the following screen:
Press F1 Button three times to return to Measurement screen of the SD270.
15.2 Conditional Survey mode
The conditional survey regroups all the measurements that had been forgotten during the
planned survey data collection.
To refresh the list of missed measurements appearing inside the conditional survey, exit
and then return to the conditional survey menu. The data previously collected will be
removed.
15.2.1 Selecting the conditional Survey mode for measurement storage
Press Enter Key, using Down Arrow highlight "Conditional Survey":
and then press Enter key one more time.
A screen propose you to select one of the uploaded surveys. Using Up or Down Arrows, highlight the chosen survey and
then press Enter Key.
15.2.2 Selecting the first Measurement
On a new screen, the SDT270 indicates to the operator:
The first measurement point with its path.
The sensor required for this first Measurement of the Survey.
The measurement order and the total of Measurements as defined with Ultranalysis Suite.
You can change the order of data collection by using the left and right arrows.
To Next Page
Loading...