Seca 452 - Page 33

Operating seca connect 103 • 33
English
17-10-01-266-002a/07-2018B
2. Scan the QR code with the scanner that is connected to the seca
measuring device or to the respective
seca 452 interface module.
The settings are transferred to the seca measuring device or the
respective seca 452 interface module.
The transmission is completed once the firmware version of the added
seca measuring device is shown under
Device settings.
You have the following options to continue:
► To add an additional seca measuring device, go back to step 1.
► To define
WiFi settings, continue with step 3.
3. Enter the parameters of the WiFi network under
WiFi:
•SSID
• Password
The QR code for the
WiFi settings is generated automatically.
4. Scan the WiFi QR code with the scanner that is connected to the seca
measuring device or to the respective seca 452 interface module.
The settings are transferred to the seca measuring device or the
respective seca 452 interface module.
Connecting the seca measuring device is complete.
5. Repeat the procedure for all seca measuring devices that you want to
connect with the
secaconnect 103.