第 52 页
4.4.4 NetService
Choose the network service option and click the set button to configure the advanced network functions
or double click the service button to configure the parameters.
Picture 4.22 NetService
【PPPoE setup】
Picture4.23 PPPOE
Enable：Reverse■ means choose,setting can become effective.
Input the user name and password that ISP（Internet service provider）provides. After saving it
reboot up your system. Then the DVR will build a network connection based on PPPoE. The IP address
will change into dynamic IP address after above operation is well done.
Operation：After PPPoE dialing successfully look up the IP address in the [IP address] and obtain
the current IP address. Then use this IP address to visit the DVR through user port.
To Next Page
Loading...
