Rostock MAX v2 User's Guide
The fan should start running at full speed. Make sure that it's spinning the correct direction by
holding your hand under the fan shroud to check for moving air. If it's not blowing air, you've likely
connected the wires backwards. :) Correct it and try again.
To turn the fan off, just click in the fan speed box and enter “0” followed by ENTER or click on
the “Set” button.
With the installation of the layer fan, your Rostock MAX v2 is totally complete and you may
now...
4 – Second Print: Layer Fan Shroud - 46
To Next Page
Loading...
