Def. Autom. Reset
The automatic reset will reset all latched LEDs, all DiggiMEC Flag Indicators, and a fault/trip
info that might be visible on the DiggiMEC display. This is done depending on this setting,
when a new protection pickup occurs or after a particular time has elapsed.
Selection list referenced by the following parameters:
• ╚═▷ Prot . Def. Autom. Reset•
Def. Autom. Reset Description
OFF (=No Autom. Reset) OFF (=No Autom. Reset)
With a New Pickup Automatic Reset when a new protection trip occurs
New Pickup or After 1 h Automatic Reset when a new protection trip occurs or after 1 hour
New Pickup or After 2 h Automatic Reset when a new protection trip occurs or after 2 hours
New Pickup or After 4 h Automatic Reset when a new protection trip occurs or after 4 hours
New Pickup or After 8 h Automatic Reset when a new protection trip occurs or after 8 hours
New Pickup or After 12 h Automatic Reset when a new protection trip occurs or after 12 hours
New Pickup or After 24 h Automatic Reset when a new protection trip occurs or after 24 hours
New Pickup or After 10 s Automatic Reset when a new protection trip occurs or after 10 seconds
Phase Sequence
Selection list referenced by the following parameters:
• ╚═▷ CT . Phase Sequence•
Phase Sequence Description
ABC Clockwise Rotating Field (“ABC” = “L1-L2-L3”)
ACB Anti-Clockwise Rotating Field (“ACB” = “L1-L3-L2”)
fN
Selection list referenced by the following parameters:
• ╚═▷ CT . f•
fN Description
50 Rated frequency
60 Rated frequency
92 WIC1 WIC1-1.0-EN-REF
11 Selection Lists
To Next Page
Loading...
Need help?
General