Sekonic LITEMASTER PRO L-478 Series - Cord Multi (Cumulative) Flash Mode

36
5-2-3. Cord Multi (Cumulative) Flash Mode
ThisMeasuringmodeisusedwhenthelight
generatedbytheashisinadequateforproper
exposure.Useasynchrocord(soldseparately)and
connecttheashtothemetertoretheash.The
repeatedashpopscanbeaccumulateduntilthe
desiredapertureisdisplayed.
Thecumulativecountisupto99times,and
displayedintheTest/TitleeldontheLCDscreen.
Toactivatethismulti(cumulative)mode,setCord
Multiple(Cumu.)FlashmodeONintheCustom
Setting (See P51 for details).
1. Connectthesynchrocord(soldseparately)to
thesynchroterminal
13
ofthemeter.
2. TouchtheMeasuringmodeicontoopen
theMeasuringModeSelectionScreen,then
touch the icontoselectCordMultiple
(Cumulative)FlashModeandreturnthe
screen view to Measuring screen. (See P25
for details.)
3. SetISOsensitivityvalueonISOicon.
4. Set shutter speed on T (shutter speed) icon.
* Besurethesettingsarewithinthe
specicationsoftheashequipment.
5. PresstheMeasuringbutton
8
on the side of
meter.
 Theashwillreandthemeasuredvalue
(f-stop)willbedisplayed.
6. Repeat this operation (pressing the
Measuringbutton
8
onthesideofmeter)
onlyforthenumberoftimesnecessary.
 Theaccumulatedmeasuredvalue(f-stop)
andthenumberofcumulativeashesare
displayed.
•
The electronic ash unit may trigger when the meter or ash is turned ON or when the synchro cord is plugged into the
meter.
•
Triggering voltage is 2.0 to 300 volts. Below 2.0V, trigger the ash with Cordless Flash Mode. (See P35 for details) or
Radio Flash Mode (Please refer to the Radio Control Flash Operating Manual).
•
When measuring a ash bulb, be sure to check the synchronization range and set the proper shutter speed.
Synchroterminal
13
Measuring screen
(CordMultiFlashMode)
Setting
values
Percentage
of ash
Measuring value (f-stop)