Sekonic LITEMASTER PRO L-478 Series - Cordless Multiple (Cumulative) Flash Mode

37
5-2-4. Cordless Multiple (Cumulative) Flash Mode
ThisMeasuringmodeisusedwhenthelightgeneratedbytheashisinadequate
forproperexposure.Therepeatedashpopscanbeaccumulateduntilthedesired
apertureisdisplayed.
Thecumulativecountisupto99times,anddisplayedintheTest/TitleeldontheLCD
screen.
Toactivatethismulti(cumulative)mode,setCordMultiple(Cumu.)FlashmodeONin
theCustomSetting(SeeP51fordetails).
Inthismeasuringmode,themeterissettomeasurestandbystatus(90seconds)by
pressingtheMeasuringbutton
8
onthesideofmeter,andduringthisstandbytime
retheashtotakemeasurements.Themeasuredvalue(f-stop)isdisplayedforeach
trigger of the ash.
1. TouchtheMeasuringmodeicontoopen
theMeasuringModeSelectionScreen,then
touch the icontoselectCordless
Multiple(Cumulative)FlashModeandreturn
the screen view to Measuring screen. (See
P25 for details.)
2. SettheISOsensitivityvalueonetheISO
icon.
3. Set the shutter speed on the T (shutter
speed) icon.
* Besurethesettingsarewithinthe
specicationsoftheashequipment.
4. PresstheMeasuringbutton
8
on the side of
meter.
 Themeterwillbeputintomeasuringstandby
modefor90secondsandthemeasuring
modeicon willblink,andtheilluminationof
LCDscreendimsnottoaffecttothereading.
5. Triggertheashunitmanuallywhilethe
Measuringmodeicon isblinking.
 Thelightwillbemeasuredandthemeasured
value(f-stop)isdisplayed.
* If90secondsperiodisexceededandthe
iconstopsblinkingbeforetheashhasbeen
triggered,presstheMeasuringbutton
8
againtoreturntoreadytomeasurestatus.
6. Evenaftermeasurement,the icon
continuesblinkingandthemeterisinready
tomeasurestatus.
7. Repeat this operation (pressing the
Measuringbutton
8
onthesideofmeter)
onlyforthenumberoftimesnecessary.
Theaccumulatedmeasuredvalue(f-stop)and
thenumberofcumulativeashesaredisplayed.
8. Torelease(cancel)themeasuringstandby
status while the icon isblinkingfor90
seconds,touchthescreen,orpresseither
theMemorybutton
5
orMenubutton
7
.
Setting
values
Percentage
of ash
Measuring screen
(Cordlessmulti
ashmode)
Measuring value (f-stop)