Sekonic LITEMASTER PRO L-478 Series - 6-7. Hardware Setting Function; 1) Hardware Setting Screen

58
6-7. Hardware Setting Function
ThefollowingsettingscanbemadeintheHardwareSettingscreen.
•
Usercalibrationofmeasuredvalue
•
Adjusttouchpaneldisplayposition
•
ReturningtoFactorysettings(defaultsettings)
•
Editinguserinformation
1) Hardware Setting Screen
1. HolddowntheMenubutton
7
and press
thePowerbutton
10
to enter the Hardware
Setting screen.
2. Touchthedesiredmenuitem.
a. UserCalibration
 ThismeterhasbeencalibratedtoSekonic
standards.However,itprovidestheability
tomatchexposuremeasurementswith
meterstometers,correctexposurefor
specialrequirements,etc.in1/10step
incrementsina+/-1.0EV.
b. AdjustTouchPanel
 Thisenablestoadjustthepositionof
touchpaneldisplay.
c. FactorySetting
 Allparametersandsettingsareinitialized
andsettofactorydefaultsetting.
 Customsettingwillbesettodefault
setting,andcustomizedFilter,framerates
andshutterangleswillbedeleted.
d. EditUserInformation
 Upto31characterscanbeenteredto
personalizethemetertodistinguish
fromothermeters,ortoinputcontact
informationincaseofloss.
 Thisuserinformationisdisplayedinthe
Informationscreen
3. PressthePowerbutton
10
to turn OFF the
power.
Menubutton
7
Powerbutton
10
Hardware Setting Screen