Selectronic Select.live - Installation and Commissioning

Installation and Commissioning Selectronic Australia
OI0009 Revision 01 Select.live User Manual 11
4 Installation and Commissioning
Based on the network selection, there are two options for the commissioning of Select.live.
Choose the method of connection that is most convenient for the installation.
• Commission of Select.live via Wi-Fi connection
• Commission of Select.live via Ethernet connection
Commission of Select.live via Wi-Fi connection
• Mount Select.live’s wall mount plate on the wall (see page 12).
• For SP PRO Series II, connect Select.live to the SP PRO via communication cable
(see page 13).
For SP PRO Series I, connect Select.live to the SP PRO via the communication
cable and power console cable (see page 14). Fix Select.live on wall mount
plate.
• Configure Select.live to connect to the SP PRO (see page 16).
• Configure Select.live to connect to the internet via Wi-Fi (see page 17).
• Complete the Setup Wizard (see page 19).
• Register to Select.live Portal (see page 21).
• Add Select.live to the Portal (see page 22).
• The commission is complete. Monitor your system (see page24).
Commission of Select.live via Ethernet connection
• Mount Select.live’s wall mount plate on the wall (see page 12).
• For SP PRO Series II, connect Select.live to the SP PRO via communication
Cable (see page 13).
For SP PRO Series I, connect Select.live to the SP PRO via the communication
cable and power console cable (see Page 14). Fix Select.live on wall mount plate
• Configure Select.live to connect to the SP PRO (see page 16).
• Configure Select.live to connect to the internet via Ethernet (see page 18).
• Connect the ethernet cable to Select.live and the router. (See page 12)
• Complete the Setup Wizard (see page 19).
• Register to Select.live Portal (see page 21).
• Add Select.live to the Portal (see page 22).
• The commission is complete. Monitor your system (see page 24).