Introduction Selectronic Australia
OI0009 Revision 01 Select.live User Manual 5
1 Introduction
Information
This document will explain the installation, operation and troubleshooting of Select.live
(Order code 005283) for SP PRO series II and for the SP PRO Series I. When installing
Select.live with SP PRO series I, the Adaptor Kit (Order code 005290) is also required.
This document doesn’t provide any detailed information about the SP PRO. For detailed
information on the SP PRO, download relevant documents from www.selectronic.com.au.
1.1.1 Validation
This document is only valid for a Select.live with hardware version 2.0 and firmware version
3.6.3 and greater. Select.live supports the SP PRO Series I in a single-phase configuration
only, or SP PRO Series II in either a single phase or Advanced Multiphase (three phase or
split phase) configuration. Select.live supports both On-grid and Off-grid systems, including
On-grid with Generator backup.
1.1.2 Glossary of Terms
Remote monitoring device connected to SP PRO System. This
is also referred as “the device” in this document
Remote monitoring Web site for SP PRO system. This is also
referred as “the portal” and “the web app” in this document
Select.live local web interface for configuration
Battery inverters from Selectronic Australia with battery, Grid,
Generator (optional) and solar PV (optional)
SP PRO System with no Grid; with battery, generator and solar
PV (optional)
SP PRO System with Battery, Grid and solar PV (optional).
On-grid with
Generator backup
SP PRO System with Battery, Grid solar PV (optional) and
Generator (optional – requires additional Grid Fail, Generator
backup kit).
A Solar PV array with a solar inverter
KiloWatt hours; the unit of Energy
State of Charge in the battery (amount of charge in the
battery) expressed as a % of the battery capacity
To Next Page
Loading...