Select.live Operation Selectronic Australia
OI0009 Revision 01 Select.live User Manual 41
• On Click of [Update Firmware] of the dialog box, starts the installation, closes the
dialog box, the firmware status changes to “FIRMWARE UPGRADE IN PROGRESS ...”
and the button is hidden as shown.
• After installation, the device reboots.
• Re-login to the device and check firmware version on bottom-right of the web
interface.
Factory Reset of the device
• Unscrew the small screw from the front of Select.live.
• Slide select.live up to unlock from wall plate.
• Locate the reset button at the back as shown on page 10.
• Press and hold the button for 20 seconds.
• On release of the button, the device factory resets and reboots.
A short press of the button, less than 5 seconds, will reboot Select.live only. For
confirmation of the factory reset, after Select.live reboots, the LCD display shows the initial
setup screen (see page 25). After factory reset, Select.live needs to complete the Setup
Wizard again for Internet connection.
To Next Page
Loading...
