Selectronic Australia Installation and Commissioning
12 OI0009 Revision 01 Select.live User Manual
Mounting
Mount Select.live on the wall in an upright position as per the following requirements:
• Select.live is recommended for indoors wall mount.
• The ambient conditions at the mounting location must be -10
o
C to 70
o
C
• Use the supplied communication cable.
• If using Ethernet to connect Select.live to the internet, the maximum length of the
Ethernet cable is 100m.
• If using Wi-Fi to connect Select.live to the internet, Select.live must be mounted in a
location with access to your Wi-Fi network.
• Protect Select.live from dust, wet conditions, corrosive substances and vapours.
The procedure to mount Select.live is as follows:
• Detach the wall mount plate from Select.live by sliding them apart.
• Drill four holes in the wall as per the dimensions below and mount the wall mount
plate on the wall using mounting screws and wall anchors. The gap on all sides of
Select.live must be at least 50 mm as shown. The gap between Select.live and
SP PRO must be at least 150mm.
• Select.live is ready to connect to SP PRO and power cables.
To Next Page
Loading...
