OmniHub CMP201– User Manual
Page 77 of 103
3.3.19.2 Service Configuration
• TS setting: Please refer to IP output service configuration.
• LCN setting: You need to add NIT stream of all frequencies in the base TS (frequency)
which is used for your STB auto search and identifies all the TS (frequencies) LCN
information.
• Check or reset each TS (frequency) Original Network ID and TS ID, which should be
different of each TS.
• Fill the Original Network ID and TS ID of each TS (frequency) in the field of the base TS
(frequency) and then click add to create a NIT stream of this TS (frequency).
• Click plus icon of Descriptor and add the TS Information Descriptor in. Then fill in the
correct parameters and then click OK. (This operation should be set on Modulator module
only)
• Click plus icon of Descriptor and add the LCN Descriptor in. Then check all the programs
which are contained in this frequency. Then set programs LCN.
• Do same operations to add next TS (frequency) until NIT streams of all the frequencies
have been included. At last click Apply button to let all configuration take effect. Then
searching programs in your STB, you will get all programs in order of LCN which you set.
To Next Page
Loading...
Need help?
General
