SERVOPRO NOx Analyzers Page
Use the Up/Down arrows to highlight the field you intend to change. Press
Enter to open the field to change the time (in seconds). After making your change,
press Enter again to close the field. Press the Back button to exit the screen
and return to the Measure Settings screen.
NO
X
CORRECTION FACTORS
→
→
→
→
or
→
Press to access the NO
x
Correction Factors menu from the Measure Settings menu.
Notes:
NO
x
Correction Factors is for advanced operators only and not necessary for
normal operation.
NOTE: NO
x
Correction Factors allows the operator to adjust small offsets between the
NO and NOx modes while operating in the NO/NO
x
/NO
2
mode.
To Next Page
Loading...
