SERVOPRO NOx Analyzers Page
Press Enter to open the field to change the time. After making your change, press
Enter again to close the field. Press to save your changes and restart the
averaging of the measured concentration. You will return to the Measure Settings menu
NO/NO
X
/NO
2
MODE TIMES
→
→
→
→
From Measure Settings menu press to access the NO/NO
x
/NO
2
Mode Times screen.
The Purge and Integration times are set to allow adequate purging and integration times
between the NO and NO
x
cycles. Any gas remaining in the sample stream from the
previous mode is purged before integration into the next mode. All NO and NO
x
readings
are displayed as averaged values, and the sample read times can be adjusted by the
operator. See
NO/NO
x
/NO
2
Mode for more information.
NOTE: The NO/NO
x
/NO
2
Mode Times screen allows the operator to set the Purge
Time and the Integration Time.
To Next Page
Loading...
