SERVOPRO NOx Analyzers Page
The Measure Settings menu is accessed by pressing from the Setup menu.
Press to view or change the Averaging Time of the measured concentration.
Press to view or change NO/NO
x
/NO
2
mode switching times.
Press to view or set the NO
x
Correction Factors.
AVERAGING TIME
→
→
→
→
From Measure Settings menu press to access the Averaging Time screen.
The Averaging Time is a sliding average. As shown above, it can be set from 0 – 60
seconds.
NOTE: The Averaging Time screen allows the operator to set the averaging time of
the measured concentration.
To Next Page
Loading...
