SERVOPRO NOx Analyzers Page
AUTO START SETTINGS
→
→
→
The Auto Start Settings screen is accessed by pressing from the Setup menu.
If the Auto Startup function is turned off, the analyzer will boot up with the same settings the
analyzer was last in. The operator can set the following parameters:
Parameters Functional Setting
Auto Startup Turn the Auto Startup function on or off.
Wait for (min) Allow for the time it takes for the analyzer to warm up before
calibration.
Calibrations Set the number of calibrations the analyzer will perform
Start Range Specify the range to set upon Power Up.
Access Level Select the Operator Security Level.
Remote/Manual Set whether the analyzer starts up in Remote or Manual mode.
NO/NO
x
Mode Select the mode the analyzer starts up in; NO, NO
x
or
NO/NO
x
/NO
2
mode.
NOTE: The Auto Start Settings screen allows the operator to set parameters that will
take effect upon power up of the analyzer.
To Next Page
Loading...
