SERVOPRO NOx Analyzers Page
From the Alarm Limits menu, press to access the Concentration Alarm Limits screen.
Use the left or right arrow to highlight the concentration alarm limit you intend to
change. Press Enter to open the field to change the value. After making a change, press
Enter again to close the field. After the concentration limit is set, specify whether the
alarm will be set for a High or Low alarm. Use the left or right arrow to highlight the
alarm type (High or Low). Press Enter to toggle between Hi or Lo. Press to save
your changes.
To set the alarm to a digital output, see Programmable Digitals
Output Assignments.
ALARM DISPLAY ON/OFF
→
→
→
NOTE: Concentration alarms can be set to trigger an alarm below or above a
specified concentration.
To Next Page
Loading...
