SERVOPRO NOx Analyzers Page
The second parameter the operator can change is the Mode. The SERVOPRO NOx
analyzer can calibrate in either NO or NOx mode. Press Enter to open the field and
select the mode using the up/down arrows . Press Enter to close the field.
Calibration Gases gives you a choice of calibrating with Zero gas only or All calibration
gases (zero and span gases). Press Enter to open the field and change the parameter
using the up/down arrows . Press Enter to close the field.
Press to save your settings. Once your changes have been saved, the analyzer will
return you to the Calibration Setup menu.
To Next Page
Loading...
