SEW-Eurodrive MAXOLUTION MAXO-MS - Specialist for electrotechnical work; Additional qualifications; Instructed persons; Designated use

2
Safety notes
Designated use
Assembly and Operating Instructions – MAXO-MS/M/SM-GIOP Sensor Module
8
Specialist for elec-
trotechnical work
Any electrotechnical work may be performed only by electrically skilled persons with a
suitable education. Electrically skilled persons in the context of this documentation are
persons who are familiar with electrical installation, startup, troubleshooting, and main-
tenance of the product who possess the following qualifications:
• Qualifications in the field of electrical engineering in accordance with the national
regulations
• Familiarity with this documentation
Additional qualific-
ations
In addition to that, these persons must be familiar with the valid safety regulations and
laws, as well as with the requirements of the standards, directives, and laws specified
in this documentation.
The persons must have the express authorization of the company to operate, pro-
gram, parameterize, label, and ground devices, systems, and circuits in accordance
with the standards of safety technology.
Instructed persons All work in the areas of transportation, storage, operation and waste disposal must be
carried out by persons who are trained appropriately. The purpose of the training is to
give persons the ability to perform the required tasks and work steps in a safe and cor-
rect manner.
2.4 Designated use
The product consists of a unit with the following sensors, which are used for track
guidance:
• 2 acceleration sensors for the X and Y axes
• 2 rotation rate sensors for the Z axis
• 1 inductive track guidance
• 1 read head for RFID transponders
Moreover, the product is equipped with a connection for the power supply and com-
munication interfaces:
• 2 EtherCAT
®
interfaces (IN and OUT)
• 2 CAN interfaces
• RS422 interface for external optical track guidance (optional)
• DC24V supply
The product is designed for installation in mobile electrical systems or machines, es-
pecially for automated guided vehicles.
In case of installation in electrical systems or machines, startup of the product is pro-
hibited until it is determined that the machine meets the requirements stipulated in the
local laws and directives. For Europe, Machinery Directive 2006/42/EC as well as the
EMC Directive 2014/30/EU apply. Observe EN60204-1 (Safety of machinery - elec-
trical equipment of machines). The product meets the requirements stipulated in the
Low Voltage Directive 2014/35/EU.
Technical data and information on the connection conditions are provided on the
nameplate and in chapter "Technical data" in the documentation. Always comply with
the data and conditions.
26868113/EN – 03/2021