SEW-Eurodrive MAXOLUTION MAXO-MS - Network security and access protection; Transport; Installation;assembly; Restrictions of use

2
Safety notes
Network security and access protection
Assembly and Operating Instructions – MAXO-MS/M/SM-GIOP Sensor Module
9
Observe the following restrictions:
• Do not open the product.
Safe and fault-free operation can no longer be ensured if you open the product. In
case of service, send your product back to SEW‑EURODRIVE. Your right to claim
under warranty no longer applies if you open the product.
• Do not make any changes to the product.
Your right to claim under warranty no longer applies if you make changes to the
product.
Unintended or improper use of the product may result in severe injury to persons and
damage to property.
2.5 Network security and access protection
A bus system makes it possible to adapt electronic drive technology components to
the particulars of the machinery within wide limits. There is a risk that a change of pa-
rameters that cannot be detected externally may result in unexpected but not uncon-
trolled system behavior and may have a negative impact on operational safety, system
availability, or data security.
Ensure that unauthorized access is prevented, especially with respect to Ethernet-
based networked systems and engineering interfaces.
2.6 Transport
Inspect the shipment for damage as soon as you receive the delivery. Inform the ship-
ping company immediately about any damage. If the product is damaged, it must not
be assembled, installed or started up.
When you return the product, pack it into a suitable box.
Observe the information on climatic conditions in chapter "Technical data" of the docu-
mentation.
2.7 Installation/assembly
When installed in an automated guided vehicle system, adjacent or attached compo-
nents must not result in exceeding the permitted operating temperature of the device.
Protect the product from strong mechanical strain. The product and its mounting parts
must never protrude into the path of persons or vehicles. Electrical components must
not be mechanically damaged or destroyed.
2.7.1 Restrictions of use
The following applications are prohibited unless the device is explicitly designed for
such use:
• Use in potentially explosive atmospheres
• Use in areas exposed to harmful oils, acids, gases, vapors, dust, and radiation
• Operation in applications with impermissibly high mechanical vibration and shock
loads in excess of the regulations stipulated in EN61800-5-1
• Use at an elevation greater than 2000m above sea level
26868113/EN – 03/2021