Sharp DX-2500N - Page 697

7-35
SYSTEM SETTINGS
Contents
*1 The productivity kit is required.
*2 When a paper drawer is installed.
*3 When a finisher is installed.
*4 When a punch module is installed.
*5 When a colour-related problem has occurred.
Copy Function Settings
 Disabling of Tray Settings Disabled 7-71
 Disabling of Finisher*
3
Disabled 7-71
 Disabling of Offset Disabled 7-71
 Disabling of Stapler*
3
Disabled 7-71
 Disabling of Punch*
4
Disabled 7-71
 Disabling of Colour Mode*
5
Disabled 7-71
l Fusing Control Settings 60 - 89 g /m
2
(16 - 23 lbs.) 7-71
Item Factory default setting Page
n Copy Function Settings
7-72
l Initial Status Settings
7-72
 Colour Mode Full Colour
 Paper Tray Varies depending on the machine
configuration
 Exposure Type Auto
 Copy Ratio 100%
 2-Sided Copy 1-Side to 1-Side
 Output –
l Other Settings 7-73
 Copy Exposure Adjustment
7-73  Colour 5
 Black & White 5
 Rotation Copy Setting Enabled 7-73
 Add or Change Extra Preset Ratios – 7-73
 Setting a Maximum Number of Copies 999 7-73
 Initial Margin Shift Setting
7-73  Side 1 10 mm (1/2")
 Side 2 10 mm (1/2")
 Erase Width Adjustment
7-73  Edge Clearance Width 10 mm (1/2")
 Centre Clearance Width 10 mm (1/2")
Item Factory default setting Page