Sharp ER-A421 - Set PLU Table; Link PLU Table (for PLU;EAN Link)

129
■
Set PLU table
When you want to make some deduction for set sellings, set PLU should be specifi ed, a PLU (set PLU)
can have a maximum of 5 tied PLUs.
Procedure
Program each item as follows:
Select a pertinent set PLU table.
▼
• SET PLU (Use the numeric entry)
Set PLU number (1 through 99)
• SET PLU #X
Enter tied PLU codes (max. 5 PLUs).
NOTE
• PLU codes should be defi ned before programming a
Menu PLU.
• If the
;
key is pressed on the table number
selection menu, the set PLU table in the cursor
position will be deleted.
■
Link PLU table (for PLU/EAN link)
It is possible to link PLUs (linked PLUs) with a PLU or EAN (link PLU/EAN) so that with a single key
depression of the link PLU or EAN key. However, the number of linked PLUs is a maximum of 10.
Procedure
Program each item as follows:
Select a pertinent link PLU table.
▼
The screen continues.
• LINK PLU TABLE (Use the numeric entry)
Link PLU table number (1 through 99)
• ITEM #XX
Enter linked PLU codes (max. 10 PLUs).
NOTE
• PLU codes should be defi ned before programming a
link PLU table.
• If the
;
key is pressed on the table number
selection menu, the selected table will be deleted.