173
■
Stacked report
Your register is equipped with the stacked report printing function that enables multiple X/Z reports to be
printed in sequence with a single request.
Procedure
Select a stacked report no. from
the list.
▼
▼
▼
When you are allowed to set the
parameter of a report, the following
window will appear.
You can select a maximum of twenty reports from the stacked
reports list. Some reports can be set their parameters such as
“START CODE” and “END CODE”.
• 01 GENERAL
General report
• 02 DEPT./GROUP
Full department report
• 03 GROUP TOTAL
Full group total report on departments
• 04 PLU/EAN (Use the numeric entry)
PLU/EAN report by specifi ed range
Parameter: Starting PLU/EAN code/ending PLU/EAN code
(1 through 99999999999999)
• 05 PLU GROUP TOTAL
Full group total report on PLUs
• 06 PLU/EAN STOCK (Use the numeric entry)
PLU/EAN stock report
Parameter: Starting PLU/EAN code/ending PLU/EAN code
(1 through 99999999999999)
• 07 PLU/EAN 0 SALES
PLU/EAN zero sales report
• 08 PLU CATEGORY (Use the numeric entry)
PLU/EAN by price category
Parameter: Starting price/ending price
• 09 TRANSACTION
Transaction report
• 10 TL-ID
Total in drawer report
• 11 COMMISSION
Commission sales report
• 12 ALL CLERK
Full clerk report
• 13 ALL CASHIER
Full cashier report
• 14 HOURLY (Use the numeric entry)
Hourly report
Parameter: Starting time/ending time (0 through 2330)
NOTE
To take the hourly Z report, you have to specify the full-range hourly report.
To Next Page
Loading...
